Use RainBird Existing 24v Tranformer?

[AustinTechie]

My current system is a Rainbird controller. The transformer is hardwired into the wall from the ceiling AC outlet placed there for the garage door opener. I have no AC outlet close to the existing timer, so was wondering if I can use the existing transformer. While the RB controller is a "24v low voltage device", the transformer says the output rating is"26.8 1A".

Question: is it safe to use this existing transformer? I really don't want to have to graft the new HydroFlash transformer onto the existing embedded wiring.

Thanks in advance for any responses.

AustinTechie (Tony)

[Support]

Hi Tony,

That transformer should work fine for you.

[AustinTechie]

Thanks for the quick response

[Nomad]

I have the same problem, but my existing transformer is 26v 750ma.

Is there a manual that shows the technical specifications for the hydroflash? I'd like to know the input range for the device.

[Support]

That transformer will work fine however we ship it with a 26VAC 1A power module.
With the smaller output current you will be limited to 3 valves max on at any one time, which is not an issue for most folks as they typically do not have overlapping programming due to water pressure limitations. Keep in mind however that manually turning on 4 valves(max limit) may and will likely not work well because of the current limited power supply resulting in blowing the replaceable internal fuse in your HydroFLASH.