Page 1 of 1

new button front

PostPosted: Wed Sep 17, 2014 5:43 pm
by Kajioka
I just received to new button fronts with with 4 pin connector. but when plug into the plug on the controller above the screen it sticks to far out to screw front panel back on. what do I do?

thanks
keith

Re: new button front

PostPosted: Wed Sep 17, 2014 8:15 pm
by Support
It plugs into the connector below the Ethernet module at the bottom. Not at the connector at the top which is a 5 pin. You could damage thr ribbon cable if you use that one and attempt to force the cover on.

Plug into matching 4 pin connector. Cable will go over top of module laying flat and easy to place cover on.

See the photo of the proper connector placement here.
http://forum.hydroflash.net/viewtopic.php?f=3&t=260

Re: new button front

PostPosted: Tue Oct 27, 2015 5:11 am
by dancalvin12
i want to see some images of that button, would you please upload some for me. I would really appreciate if you do this.