Page 1 of 1

Hydroflash Front Panel Button

PostPosted: Sat Apr 25, 2015 9:50 pm
by twander1
Can you provide instructions on using the front panel "Man" and "Ent" buttons? Do these both work on products delivered in 2015 or do I need to purchase an upgrade to control manually? Thanks, Tom

Re: Hydroflash Front Panel Button

PostPosted: Sun Apr 26, 2015 3:52 pm
by Support
Press the MAN button repeatedly to select the desired Station to run, then press the ENT button to turn it ON.
Press the ENT button again (when manually running a station or stations) will turn them OFF.

The menu will time out and return to its display cycle after a few seconds if you press the MAN button and don't press the ENT key.

The Manual run time value when using the front panel uses the default time in minutes entered on the settings page.
The buttons are primarily targeted for maintenance personnel for access to test sprinklers etc.

All HydroFLASH units with the front panel buttons and updated software support the buttons. Older units can be updated to one with buttons very easily. See the link below.
viewtopic.php?f=3&t=260

Hope this helps.