Page 1 of 1

Setting up a blowout scene program

PostPosted: Tue Oct 27, 2015 4:47 am
by bdwalker
Getting ready to blow out my sprinklers and always thought I could make a scene program to do it. Can't seem to find the syntax to make it happen anyone got any thoughts?

Since my compressor is not that big it needs to re-charge after each zone. This is the sequence it would need to run...

Turn on Zone 1
Run for 5 minutes
Pause for 15 minutes
Turn on Zone 2
.... continue through all zones.

Can it be done?

Re: Setting up a blowout scene program

PostPosted: Fri Nov 23, 2018 11:28 pm
by bdwalker
Haha, I came back to see if anyone has found a solution for this... but found I already asked this same question back in 2015. I know I saw someone else talking about it on another thread.

In another thread the moderator said they were thinking about redoing something big. Would you please add this request to the list of things to add.