Page 1 of 1

Zone output voltage

PostPosted: Tue Jun 28, 2016 3:42 pm
by Kedoaj
There are zones not working on my HydroFlash WiFi controller. What should the output voltage be? I am getting very strange readings.

Re: Zone output voltage

PostPosted: Wed Jun 29, 2016 2:11 pm
by Support
Place an AC volt meter between the common connector and the zone terminal. When ON it should read about 26V AC. First measure the AC output from the transformer with all zones OFF to verify it reads around 26V.

What voltages are you seeing?