Page 1 of 1

X10 Control

PostPosted: Sat Mar 22, 2014 3:47 pm
by Superspike711
If I have an X10 device programmed into the PLM (Serial Modem) can I control it with Hydroflash?
How should I enter the address?
In Houselinc a X10 device has ID "House A Unit 4"
Thx,
Spike

Re: X10 Control

PostPosted: Sat Mar 22, 2014 5:40 pm
by Support
Hi Spike,

While the Insteon PLM does have provisions to communicate with the older X10 devices, HydroFLASH does not currently support the X-10 devices. This 'could' be supported in the future but there has been little demand for use with the X10 devices. The Insteon protocol is a much more reliable protocol as I am sure your are aware.

Do you have a legacy X10 system that you want to control from HF? How many X10 devices do you have?

Do you currently own a HydroFLASH controller?