Current system includes a HydroFLASH controller connected to an INSTEON 2413S Serial Interface, INSTEON 74551 Garage Door Control and Status Kit. I have a scene that turns on the front porch lights when a motion sensor triggers, but I can't seem to get the same scene to run when the garage door opens. The garage door correctly shows up as open or closed on the status page, and I can open and close it through the manual Insteon momentary control.
I have the events set up as follows;
And I am able to manually run the scene, which is about as simple as it gets;
Front Outside Lights,ON,NONE,NONE
One difference that I can see is I always get a log entry when the motion detector
Sun 12-06-2015 08:20:48 - Device 'Motion Detector' Commanded Insteon Scene 'Alert-TurnOnFrontLights' to Run
But I don't see anything similar for the garage door triggering its event.
Thanks in advance for suggestions.