Page 1 of 1

Can't “Add Controller" in iPhone App

PostPosted: Tue Jul 15, 2014 11:38 pm
by XL5
Hello,

I am unable to use the iPhone app. I have read (the hard to read) instructions built into the app. But I remain confused.

The instructions appear to be geared towards the Wi-Fi version. However, I have a wired version.

I enter the IP address shown on the controller display. I have tried various passwords including “hydroflash” and the password I used signing into this forum and website. For "Port" I am using the number shown on the controller display. When I click on “Pair” I get “Connection Error, socket closed by remote peer”.

Suggestions appreciated.

Re: Can't “Add Controller" in iPhone App

PostPosted: Fri Jul 25, 2014 4:53 pm
by Support
Phone call to customer resolved issue during setup.